The Leading Amusement Ride Manufacturer in China.

Standards and Measures for Large Amusement Equipment

by:Jinma Rides     2022-09-20
Standards and Measures for Large Amusement Equipment


237
2021/9/24 6:05:38


There are many amusement equipment play items, such as luxury carousel, bumper car, Ferris wheel, roller coaster, sightseeing car, etc. Some of the amusement equipment runs in the air. Such a play item requires that its overall structure should be firm and reliable, and its important zero Parts should take insurance measures. Here is a detailed introduction to the standards and measures of large amusement equipment:

1. Insurance measures
The overall structure of the passenger part of the amusement equipment running in the air should be firm and reliable, and insurance measures should be taken for its important parts.

The number of wire ropes or chains used for suspending the passenger part shall not be less than two. The connection with the seat part must be considered to be able to maintain balance when one is disconnected.





The door that closes the cockpit above 1m from the ground must be equipped with two locking devices or a locking device with safety that cannot be opened by passengers inside. Blocks at the entrance and exit of the non-enclosed cockpit should also have a locking device with safety.

When the amusement equipment is in operation, the power supply is suddenly cut off or the equipment fails, endangering the passengers, an automatic or manual emergency stop device must be provided.
After a failure in operation,
There should be measures to relieve passengers.

2. Passenger restraint device
When the amusement equipment is running, when the passengers may be moved, collided, or thrown out or slipped out of the ride, a passenger restraint device must be provided. For the more dangerous amusement equipment, two sets of independent restraint devices should be considered if necessary. Belts, pressure bars, stop bars, etc. can be used.
Restraint device: It should be reliable and comfortable, and the parts in direct contact with the passenger should have appropriate softness. The restraint device should be designed to prevent a certain part of the passenger from being pinched or crushed, and should be easy to adjust and operate.
Belt: It can be used alone on the equipment with slight swing or slow lifting speed, no flipping and no danger of being thrown out. Generally, the belt should be equipped with an auxiliary handle. For vigorous equipment, the belt can be used as an auxiliary restraint device.
Pressure bar: When the amusement equipment is running, it may cause the danger of passengers being thrown out, and a corresponding type of pressure bar must be set; and remain locked until the device stops functioning.
3. Requirements for fences and platforms
Fences should be set at the entrance and exit respectively, and guide fences should be set at the entrance. The platform should have anti-skid measures.
The opening direction of the fence gate should be consistent with the direction of travel of passengers (except in special circumstances). In order to prevent injury to the hands of personnel when the door is closed, the gap between the door frame and the column should be appropriate, or other protective measures should be taken.
For amusement equipment that rides on and off while running, the entrance and exit of the passenger part should not be higher than 300 mm from the platform. The height of the entrance and exit of the passenger part of other amusement equipment from the platform should be easy to get on and off.

4. Other requirements

Amusement equipment should be set up with conspicuous signs in necessary places and parts. The signs are divided into four types: prohibition signs (red), warning signs (yellow), instruction signs (blue), and prompt signs (green).
Custom message
Chat Online
Chat Online
Chat Online inputting...
Sign in with: