The materials of each part of the children's play equipment are different, so the cleaning method should also be different

The materials of each part of the children's play equipment are different, so the cleaning method should also be different

2019-09-25 17:31:50107

The cleaning of children's play equipment is very important. Only by cleaning the children's play equipment can we ensure the hygiene and health of the children's play equipment. What needs to be done for the cleaning of various children's play equipment: The materials of each part of the children's play equipment are different, so the cleaning methods should also be different. Plastic and fiberglass children's play equipment can be diluted with soapy water, disinfected with washing powder, bleach for cleaning equipment used in field equipment, etc., then scrub with a soft cloth or soft brush, then rinse with water, then dry or dry with detergent cloth. Disinfect with 84 disinfectants. Metal parts of children's playground equipment can be brushed onto the floating embroidery and wiped with a dry cloth. You can spray the children's play once in the sun, and then spray it again when it dries, to protect it, etc. Wash and sanitize after drying. The electrical parts of the circuit must be disconnected during cleaning. It is forbidden to rinse directly with water. Usually, scrub with a damp cloth. After drying, connect it to the power supply of the children's play equipment. The sponge portion of children's playground equipment can be scrubbed with a soft cloth dampened in soapy water or exposed to sunlight. Heat-resistant, moisture-resistant, colorfast wooden parts can be washed with soapy water, dried and then sterilized. If it is an indoor sports field, floor, wall, etc., it should be disinfected with ultraviolet rays every day, and the room should be ventilated frequently. Disinfect with hydrogen peroxide once a week. To ensure the health and safety of children, operators of children's playground equipment should not be lazy. Equipment Specifications for Playground Equipment First of all, the allowable value of acceleration has been increased for sliding classes such as 'roller coaster'. This is because when the 'roller coaster' descends from a higher point to a lower point, the speed is very fast and the acceleration is also great. To prevent injury to passengers, acceleration should be limited to a certain range. Equipment Specifications Second, various loads, such as wind loads, are added. Because when the wind is above the sixth level, its own speed is added to the impact force. It is very dangerous to throw passengers out. The taxiing operation must be stopped. Third, playground equipment has been adjusted and the safety factor reduced. Common materials can meet safety requirements, while the previous safety factor was set too high, resulting in material waste and increased cost.