How to deal with the fault of the carousel amusement equipment-

　How to deal with the trouble of the horse-drawn amusement equipment? 580 times 2019-07-26 14:45:19　 Core reminder: There are many amusement equipment, and the amusement equipment will malfunction during operation, so how to solve the problem? 1. Unable to start 1. Electric control cabinet and circuit failure. If it fails to start, first check whether the electric control cabinet is working, first check whether the power indicator of the electric control cabinet is on.

Nowadays, there are many amusement equipment, and the amusement equipment will fail when it is running, so how to solve the problem?
One, can not start
1. Electric control cabinet and circuit failure. If it fails to start, first check whether the electric control cabinet is working. First, check whether the power indicator of the electric control cabinet is on. If the indicator is on, it means that there is no problem with the power supply connected to the electric control cabinet. If the indicator is not on, check first. Whether there is any disconnection or short-circuit in the line connecting the power supply to the electric control cabinet, if there is, reconnect or replace the line. If there is no problem, then open the electric control cabinet to check whether the relay knife is closed and whether the fuse is blown. If so, close and replace it. If the fault still exists, check whether the circuit connecting the electric control cabinet to the Zhuanma conductive ring is disconnected (the location of the conductive ring is at the center column of the Zhuanma), and whether the circuit from the conductive ring to the motor is disconnected. If so, reconnect or replace it. line. Check the contact part of the conductive ring and the carbon brush for dust and poor contact. If so, you can press it with a screwdriver a few times.
2. Motor failure. If there is no fault in the electrical control cabinet or the circuit or the troubleshooting still cannot start, check whether the motor is faulty, remove the belt on the motor pulley, start the power button on the electrical control cabinet, and then see if the motor is working, if it does not work, then The motor is damaged and needs to be replaced.

Second, difficult to start
1. The bearing is too tight. This kind of failure usually occurs in the case of new rotating horses. It can be adjusted with a wrench, and the tightness is moderate. In addition, the effect of adding lubricating oil is better.
2. The voltage is unstable or too low. Many equipment start difficulties or fail to start because the voltage is unstable or too low, mainly caused by the excessive voltage load nearby. This phenomenon is especially obvious in summer. The way to check is to press the start button of the electric control cabinet and observe whether the voltmeter is normal. The solution is to replace the power cord with a larger square number or replace the line access point. The direct but not effective way is to press the start button of the electric control cabinet, and then find two people to push the market to see if it can work normally.
3. The triangle belt is loose. If the V-belt is loose, you can adjust the distance between the motor and the pulley or replace it with a new V-belt of the same model.

3. Excessive jitter and noise. The problem of jitter and excessive noise is

First, it is caused by the uneven running of the market. You can check whether the tires are leaking or not. If the air pressure is not enough, replace or repair if the air leaks. If the air pressure is not enough, you can inflate the tires, generally three and a half air pressure is enough.

The second is because the friction between the transmission part and the bearing increases, you can add lubricating oil.