Briefly talk about the standards of amusement equipment

Briefly talk about the standards of amusement equipment

333

2021/9/24 9:20:29

insurance measures

The overall structure of the passenger part of the amusement facility running in the air should be firm and reliable, and insurance measures should be taken for its important parts.

The number of wire ropes or chains used for suspending the passenger part shall not be less than two. The connection with the seat part must be considered to be able to maintain balance when one is disconnected.

The door that closes the cockpit above 1m from the ground must be equipped with two locking devices or a locking device with safety that cannot be opened by passengers inside. Blocks at the entrance and exit of the non-enclosed cockpit should also have a locking device with safety.

When the amusement facility is in operation, the power supply is suddenly cut off or the equipment fails, which endangers the passengers, and an automatic or manual emergency stop device must be provided.

After the amusement equipment fails during operation, measures should be taken to relieve the passengers.

Passenger restraint device

When the amusement equipment is in operation, when the passengers may be moved, collided, or thrown or slipped out of the ride, a passenger restraint device must be provided. For more dangerous amusement facilities, two sets of independent restraint devices should be considered if necessary. Belts, pressure bars, stop bars, etc. can be used.

Restraint device: It should be reliable and comfortable, and the parts in direct contact with the passenger should have appropriate softness. The restraint device should be designed to prevent a certain part of the passenger from being pinched or crushed, and should be easy to adjust and operate.

Belt: It can be used alone on the facilities with slight swing or slow lifting speed, no flipping and no danger of being thrown out. Generally, the belt should be equipped with an auxiliary handle. For intense sports facilities, the belt can be used as an auxiliary restraint device.

Pressure bars: When the amusement facilities are running, when there is a danger that the passengers may be thrown out, a corresponding type of pressure bars must be set; and remain locked until the device stops functioning.

Requirements for fences and platforms

Fences should be set at the entrance and exit respectively, and guide fences should be set at the entrance. The platform should have anti-skid measures.

The opening direction of the fence gate should be consistent with the direction of travel of passengers (except in special circumstances). In order to prevent injury to the hands of personnel when the door is closed, the gap between the door frame and the column should be appropriate, or other protective measures should be taken.

For amusement facilities that ride on and off while running, the entrance and exit of the passenger part should not be higher than 300 mm from the platform. The height of the entrance and exit of the passenger part of other amusement facilities from the platform should be easy to get on and off.

other requirements

Amusement facilities should set up conspicuous signs in necessary places and parts. The signs are divided into four types: prohibition signs (red), warning signs (yellow), instruction signs (blue), and prompt signs (green).

No exposed sharp edges, sharp corners, burrs and dangerous protrusions are allowed where passengers can reach.

The culvert through which the amusement facilities pass should be made of materials that are not easy to fall off, and the decorations should be firmly fixed.